Shelf and range photos for a bottle shop's website and socials
An independent bottle shop lives on two kinds of photo: the range shot that shows you actually carry depth in a category, and the single new-arrival shot that goes out the day a case lands. Both are taken in the least forgiving room you own — narrow aisles, overhead strip lighting, glass doors on the chillers, and forty labels per frame, each one competing for attention. The result is usually a photo where the labels closest to the camera lean outward, a bright bar of light runs across the middle shelf, and you can see the aisle behind you reflected in the fridge door. None of that is a camera problem. It is a standing-position problem, a tidying problem and a lighting-direction problem, and all three are fixable in the ten minutes before you press the shutter.
Face the shelf before you photograph it
The single biggest improvement to a shelf photo happens before the camera comes out. Pull every bottle forward to the shelf edge, rotate each one so the front label faces straight out, and close the gaps where the last customer took something. A shelf that is faced photographs as a wall of clean, aligned artwork. A shelf that is not faced photographs as a jumble with dark holes in it, and no amount of editing will move a bottle that is sitting two inches back in shadow.
Take the shelf-talkers seriously too. Price cards that are curled, out of date or hanging off a wire will be legible in a high-resolution photo even if you cannot read them standing there. If a price appears in an image you publish, it should be the price you will honour, or you should reshoot without it. Removing a price card in an edit is fine; changing a printed number so it says something else is not, and it is the kind of thing that comes back to you at the till.
Dust is the other silent killer. Bottle shoulders and the tops of boxes collect a grey film that reads as haze in the photo, particularly on dark glass. A microfibre cloth along the row you are shooting takes a minute and saves you from a photo that looks tired for reasons you cannot name.
Shoot straight on, from the middle of the shelf's height
Labels stay square when the camera's sensor plane is parallel to the shelf face and level with the middle of the section you are shooting. Stand back, hold the phone vertically flat rather than tilted up or down, and centre it on the third shelf of a five-shelf bay. Every label then reads as a rectangle. Tilt the phone up and the top row keys outwards; step to one side and the labels at the far end skew until you cannot read them.
Wide phone lenses stretch whatever sits near the frame edge, which is exactly where your end-of-row bottles are. The fix is to back up further than feels necessary and shoot one bay at a time rather than trying to fit three bays into one frame. A tighter section shot at a distance beats a wide sweep every time, and three clean bay photos post better than one panoramic blur.
If the aisle is too narrow to back up, shoot the shelf in vertical slices and post them as a small set. It is more honest about what the shop looks like than a heavily distorted wide shot, and it lets a customer actually read what you stock.
Strip lighting, chiller doors and the reflection of you
Overhead fluorescent or LED strips run parallel to the aisle, which means they land as a long bright band across the top of every bottle and leave the labels in relative shadow. You cannot move the ceiling, but you can move yourself: standing slightly off the exact centre of the aisle often shifts the specular band off the label faces and onto the shoulders, where it does no harm. Take two frames a step apart and compare.
Glass chiller doors are mirrors pointed at the aisle. Whatever is behind you — you, your phone, the far shelving, the entrance — will appear in them. Either open the door and shoot the product directly, which usually looks better anyway, or find the angle where the reflection lands on the dark uprights between products rather than across the cans. Wearing dark clothing while shooting reduces how much of you shows up, which sounds absurd until you compare a shot taken in a black shirt with one taken in a white apron.
Mixed colour temperature is the last problem: cool strip lighting overhead, warmer spots over the counter, daylight through the shopfront. Pick the one that dominates the frame and correct the whole image to that, rather than chasing all three. If you use Foxi AI for the cleanup, this is what a look does well — it evens out the cast and the exposure across a whole shelf without you having to think about which light source is which. What it does not and should not do is alter the printed label artwork, so the bottle you photograph stays the bottle a customer picks up.
New arrivals deserve their own shot, not a shelf crop
The new-arrival post is a different job from the range shot. Take the bottle out of the rack, put it on a clean surface — the counter with everything cleared, a wooden board, a plain shelf against a plain wall — and shoot it on its own with light coming from one side rather than from directly overhead. It takes two minutes and produces an image that reads at thumbnail size in a feed, which a cropped shelf photo never will.
Give the bottle a little space around it so the image survives being cropped square, vertical and wide by different platforms. Aspect ratios and display crops change without warning, so shoot loose and check the current guidance from whichever platform you are posting to rather than assuming last year's dimensions still apply.
If you shoot every new arrival the same way — same surface, same light direction, same distance — your feed develops a recognisable look without any styling effort. Consistency here is worth more than any single clever photo.
- One bottle, front label square to camera, filling most of the frame height
- A close crop of the label detail worth talking about — vintage, ABV, producer mark
- The bottle in the hand or beside a glass, for scale and context
- The row on the shelf so a customer knows where to find it in store
Keep the product honest, clean up everything else
The line to hold is simple: the photograph can be improved, the product cannot be changed. Evening out exposure, removing a scuff on the shelf, lifting shadow on a dark bottle and correcting a green fluorescent cast all describe the bottle more accurately than the raw phone frame did. Deepening a wine's colour, smoothing a damaged label, removing a fill-level line or brightening a spirit to look older are misrepresentations of stock a customer is about to buy.
This matters more in retail than in producer marketing because your customer is comparing the photo to the physical bottle within minutes. A shelf photo that flatters gets you one sale and one disappointed regular. Where a bottle genuinely has a torn label or a low fill because it is an old release, say so in the caption and photograph it as it is.
Build a small routine you can repeat weekly
Fix a slot — say, Tuesday morning before opening — when the shop is empty, the shelves are freshly faced and no one needs the aisle. Shoot the bays that changed, plus each genuinely new arrival, in one pass. Twenty minutes a week produces more usable images than an occasional ambitious session that never happens.
Keep the images in one place with the product name in the filename. The reason range photos go stale is not that they were bad, but that nobody can find the good one when the listing needs updating. A shared folder named by category, with the date in the filename, solves a problem that will otherwise cost you the same twenty minutes over again every month.
Frequently asked
Should I shoot with the chiller doors open or closed?
Open, where practical. Glass doors reflect the aisle and everything in it, including you, and the reflections sit right across the product faces. If the door has to stay closed, shift your standing position until the reflection falls on the dark frame between products rather than on the cans.
Can I edit out a competitor's product or a messy end of the shelf?
Removing clutter, a stray box or a distracting background object is normal cleanup. Removing or replacing products to imply you stock something you do not, or to hide that a section is nearly empty, is misleading and will be obvious to anyone who walks in. Restock first, photograph second.
What do I do about prices showing in shelf photos?
Either make sure the visible prices are current before you shoot, or frame and crop so the shelf-talkers are not readable. Never alter a printed price in an edit. Pricing claims in published images can fall under consumer advertising rules that vary by market, so check what applies where you trade.
Do drinks images posted by a retailer count as alcohol advertising?
That depends entirely on where you are. Many markets treat a retailer's social posts as advertising subject to the same codes as a producer's, and the rules around who appears in the image, whether drinking is shown and what warnings must be included vary by country, state and platform. Check with your own regulator, trade body or legal advisor before you publish.
Shoot the whole menu at once
Photograph the plate under your kitchen lights and get back something worth putting on a delivery app — appetising light, honest colour, the same dish.